Frame brazing.

February 3rd, 2013

Not much to report this time. I did get some good second hand brake shoes from the VAR spares people and have cleaned and painted them. Soon I can rivet on the new linings. I’ll make a punch on the lathe I think.

I also brazed all the joints on the frame. I still need to clean everything up and remove the flux as well as cap the ends of some tubes. And I need to weld on the rear most side panels. Then I can fit the rear firewall again and spot weld the tunnel over the rear axle in place.

So not much to see now but here is the frame so far.

IMG_3410_1 IMG_3411_1

Braze welded frame.

Leave a Reply